parte trasera biqu B1 April 1, 2026 | No Comments | configuration, information, printer 3d esto es por si necesitás saber como van el “Smart Filament Sensor” puede ir vacío El conector está ahí como puerto de expansión para accesorios […]
Enter Marlin mode on a Biqu B1 3D printer | No Comments | configuration, information, interface, printer 3d You turn on the 3D printer and then hold down the front wheel You can see the process in this video:
filler material in 3D printing March 15, 2025 | No Comments | printer 3d Gyroid fill typeIf you want something very resistant, set it to 25%. 3D printing is not 100% solid, but rather a waste of material, nor […]
printing without supports | No Comments | printer 3d The print will almost certainly turn out badly. Where there are vertical ceilings, when the material is hot, the print will turn out poorly. example: […]
3d printing project (Red Bull RB19) March 11, 2025 | No Comments | formula 1, printer 3d, rb19, redbull https://www.thingiverse.com/thing:6781408 It’s a Formula 1, a Red Bull. I had to redo the design, since it will took 11 hours and I started at 10 […]
